Links
Latency
LinuxCNC Drivers
Install
- https://forum.linuxcnc.org/9-installing-linuxcnc/39779-rpi4-raspbian-64-bit-linuxcnc
- https://forum.linuxcnc.org/9-installing-linuxcnc/49029-linuxcnc-on-rpi4-rpi3-dietpi
- https://forum.linuxcnc.org/38-general-linuxcnc-questions/44398-linuxcnc-image-for-raspberry-pi-3
- http://linuxcnc.org/docs/stable/html/getting-started/getting-linuxcnc.html
- https://docs.google.com/document/d/1jeV_4VKzVmOIzbB-ytcgsW2I_PhCm1x7oiw8VcLFdiY
- https://forum.linuxcnc.org/9-installing-linuxcnc/48512-the-case-for-debian-bookworm-and-the-6-1-kernel-including-installation-notes
Hardware
- https://forum.linuxcnc.org/27-driver-boards/32898-non-step-direction-interfaces
- https://forum.linuxcnc.org/9-installing-linuxcnc/41900-linuxcnc-at-rpi4-with-using-io-pins-only
- https://forum.duet3d.com/topic/18694/duet-maximum-achievable-step-rates/
- https://forum.linuxcnc.org/9-installing-linuxcnc/47545-installing-on-rpi-with-gpio-and-software-stepping
- https://www.a-m-c.com/what-is-dual-loop-position-control-and-where-is-it-needed/?cn-reloaded=1
Dual Loop - https://github.com/rene-dev/stmbl/blob/master/docs/src/Getting%20Started.adoc
- https://github.com/jzolee/HAL2UDP
- https://remora-docs.readthedocs.io/en/latest/
- https://forum.linuxcnc.org/38-general-linuxcnc-questions/27626-maximum-servo-thread-frequency
Frontend
- https://www.qtpyvcp.com/index.html
- https://linuxcnc.org/docs/2.9/html/gui/qtdragon.html
- https://www.forum.linuxcnc.org/38-general-linuxcnc-questions/43513-best-way-to-do-external-controls-for-linuxcnc
- http://linuxcnc.org/docs/2.9/html/config/python-interface.html
MachineKit
Based on some of the forum posts it looks as if MachineKit doesn't have a lot of recent support.
So LinuxCNC seems like the best option at the moment
FlexiHal
Table of Contents